Samsung PCB BF41-00206B Failure

Samsung PCB BF41-00206B Failure

PCB failures (Such as Samsung PCB BF41-00206B) affect thousands of hard drives every year and often result in permanent data loss. A hard drive may suddenly fail to power on, and a computer may not detect that it is plugged in. Some failed hard drives will also show up in computer BIOS with incorrect brand/model information. PCB failures can also cause physical issues such as read/write head failures, and many PCB failure symptoms overlap with the symptoms of other physical hard drive issues.

Some emails from customers of Samsung PCB BF41-00206B failures are listed below, along with tips for replacing & repairing.

Samsung PCB BF41-00206B Failures:

Q: Samsung HD103UJ PCB repair

Hi, All my google searches lead me to this site to help with my hard drive I have the following drive with a fried PCB due to a power supply fault Model Samsung HD 103UJ Size 1TB Date 200902 PCB Trinity 32MB REV 5 BF41-00206B R00 As suggested in other posts, I tested the PCB using a multimeter and found the 5V TVS Diode to be short circuited and the zero ohm resistor next to it is open circuit So I removed the 5V TVS diode and soldered a wire over the zero ohm resistor and

Q: Replacing PCB diode question – Samsung HD154UI

– shown in the picture below I did some reading about swapping the PCB but found that the chances of finding a perfect match for these new Samsung models is pretty slim, so that option probably won’t work PCB label says TRINITY 32MB REV5 BF41-00206B R00 Then I read that the diodes near the SATA power connector might just be for overvoltage protection and that my drive may still work if I simply remove them with flush cutters though it will no longer have any overvoltage protection Any

Q: Need pcb for Samsung HD753LJ

Hi guys,I need a pcb for a Samsung 750GB HD753LJ Drive with the following characteristics:HD753LJ(B)Date: 2008.08PCB:TRINITY 32MB REV5BF41-00206B R00Drive has no spinup, TVS diodes are fine, 0ohm resistor is fine and disks/motor is free.Hope a close match will get this drive to work again.Thanks for your efforts,Alwin

Q: PCB to Samsung HD103SI

Hello All! I have a Samsung HD103SI with pcb Trinity 32 mb rev 5 BF 41-00206B, is it possible to swap the card ?I think it was a short circuit.

Q: Samsung HD103UI PCB question

are not interchangeable due to parameters stored in the ICs (don’t know how true this is or if they’re just trying to sell their services) I found a spare board available online which has the same part number and revision number as my PCB (BF-41-00206B R00) but the drive model is listed as HD103UJ Will this PCB be compatible with my drive or is it going to be a waste of money? I really need to recover the data off this drive as it contains lots of family photos Any advice greatly appreciated,

Q: Samsung HD103UJ – firmware needs 1AA01118 (2009/06)

and than write the firmware from/in flash-ROM over Sata-Port My drive data Model HD103UJ (Samsung) P/N 61681A461A11LH (2009/06) firmware (original) 1AA01118 (before my problem!) S/N S13PJ1KS60 PCB-Controller Trinity 32 MB Rev 5 BF41 00206B R00 Does not now finish me please! My Problem briefly – it is the wrong firmware into the PCB (Trinity 32MB Rev5 – BF41 00206B R00) the to newer ones HD103UJ! The original firmware was 1AA01118 and by a mistake on me is now into the PCB the

Replacement Samsung PCB BF41-00206B:

To repair a failure board, the simple way is swapping the failure board with a replacement board. Donor boards on HardDriveParts.com are listed below:

Contact US

If you have any questions, please feel free to contact us: sales@harddriveparts.com

Comments are closed.