WD PCB 2060-001159 Failure

WD PCB 2060-001159 Failure

PCB failures (Such as WD PCB 2060-001159-*** (2061-001159-***)) affect thousands of hard drives every year and often result in permanent data loss. A hard drive may suddenly fail to power on, and a computer may not detect that it is plugged in. Some failed hard drives will also show up in computer BIOS with incorrect brand/model information. PCB failures can also cause physical issues such as read/write head failures, and many PCB failure symptoms overlap with the symptoms of other physical hard drive issues.

Some emails from customers of WD PCB 2060-001159 failures are listed below, along with tips for replacing & repairing.

WD PCB 2060-001159 Failures:

Q: WD600BB-00DKA0 – ROM damaged

Hi there,. I’m handled this case that comes from another lab. The original PCB (2060-001159-006) was dead, and I have the donor PCB. Unfortunately the original flash ROM has been damaged, or rather a pin is detached. There is the possibility of restoring it or rebuilding it from the SA like with the Marvel?….or is this a hopeless case? Thanks guys for any hint or help

Q: Read/Write Serial Flash on WDC Logic Boards

Hi,Method for Reading/Writing serial flash ROM on WDC Logic Boards…Tested on:2060-001159-006 REV A2060-701292-000 REV A2060-001293-001 REV A2060-701335-005 REV A…Method not work with “Mammoth” boards… :cry:Mikippp

Q: Wanted: PCB for WD800BB-00DKA0 (Board #: 2061-001159-100)

It looks like the U7 chip got fried – causes a short and the power supply switches off immediately when the computer is turned on. The sticker on the IDE port reads 2061-001159-100 BD1, while the numbers on the board itself are 2061-001159-003 REV P1. Can any one help? Also, does anybody know whether I will need to swap the firmware chips on this one?Thanks!

Q: WD800BB-00DKA0 DCM -HSBACVJAA FLASH DUMP PLEASE

WD800BB-00DKA0 DCM -HSBACVJAA FLASH DUMP PLEASETHE IC HAVE 8 PIN IN BOARD 25P2060-001159-006

Q: Need firmware for Wd400BB-75FRA0

I need firmware for Wd400BB-75FRA0, pcb:2060-001159-006 Rev A.Thanks.Ale

Q: WD800BB No power – New PCB? 🙁

and found that I need to replace the current PCB with one of a similar model number The problem is that the number on the white sticker below the IDE is slightly different from the one printed on the bottom of PCB itself White sticker = 2061 001159 100 E / Bottom of PCB = 2060 001159 006 What one would I use as a reference when finding a replacement (White sticker # or Bottom of PCB) ? Also, what is of most significance when replacing a PCB matching PCB #, hard drive model (WD800BB –

Q: Need WD PCB 2060-001159-006!

Hey guys.I have an old WD 80gb drive (WD800BB-53DKA0) that has decided to stop powering up. Come down to replacing the PCB which has been annoying to find. The PCB itself is 2060-001159-006, while the number on the port reads 2061-001159-100 EE.Does anyone have one of these??

Replacement WD PCB 2060-001159:

To repair a failure board, the simple way is swapping the failure board with a replacement board. Donor boards on HardDriveParts.com are listed below:

Contact US

If you have any questions, please feel free to contact us: sales@harddriveparts.com

Comments are closed.